Ceramic Locking Ring Fasten Holder for Precitec Raytools Wsx 1.0 2.0 Laser Head Patrs 304 Stainless Steel for Fiber Cutting Machine
The locking ring is used to hold the ceramic ring of the laser cutting head in place, keeping it stable and not moving
1. Reliable quality
2. Low friction
3. Tensile and compressive resistance
4. Withstand high temperatures
Daucus
Ceramic Locking Ring Fasten Holder for Precitec Raytools Wsx 1.0 2.0 Laser Head Patrs 304 Stainless Steel for Fiber Cutting Machine
FOR PRECITEC
| For Precitec: | |
| Outlet Diameter | 42mm |
| Inner Diameter | 25mm |
| Height | 6.8mm |
| For Precitec 2.0: | |
| Outlet Diameter | 45mm |
| Inner Diameter | 27.5mm |
| Height | 7.5mm |
——————————————————————————————————————————————————————————————
FOR RAYTOOLS
| For Raytools BT220/BM115: | |
| Outlet Diameter | 40mm |
| Inner Diameter | 25mm |
| Height | 10mm |
| For Raytools BT240/BM109: | |
| Outlet Diameter | 41mm |
| Inner Diameter | 30mm |
| Height | 11.75mm |
| For Raytools BM111: | |
| Outlet Diameter | 46mm |
| Inner Diameter | 29mm |
| Height | 10mm |
| For Raytools BT240S: | |
| Outlet Diameter | 44.5mm |
| Inner Diameter | 30mm |
| Height | 11.75mm |
——————————————————————————————————————————————————————————————
FOR WSX
| For WSX KC15: | |
| Outlet Diameter | 41mm |
| Inner Diameter | 25mm |
| Height | 7mm |
| For WSX NC30/NC60: | |
| Outlet Diameter | 41mm |
| Inner Diameter | 25mm |
| Height | 7mm |
| For WSX NC30C/SW18: | |
| Outlet Diameter | 25mm |
| Inner Diameter | 16.7mm |
| Height | 11mm |
——————————————————————————————————————————————————————————————
How do I replace the ceramic ring and locking ring?
To replace the ceramic ring, you need to unscrew the nozzle first, and then unscrew the locking ring of the ceramic ring, pay attention to the fingers against the old ceramic ring during the rotation process to prevent vertical slipping and falling. When replacing the new ceramic ring, it is necessary to align the copper pillar with the induction hole at the bottom of the cutting head, and the normally aligned ceramic ring is horizontal, which will be a little elastic and cannot be rotated left and right. Then press your finger against the ceramic ring to tighten the lock nut and finally screw the nozzle on to complete the installation. At the same time, after the installation is completed, it is also necessary to debug the beam path to prevent the deviation of the light output.
